This is a customizable order form for the Atari 2600 and the various services offered. Please note that all costs listed are for service only, requiring you to ship not only the console but the mod/upgrade parts you have purchased yourself (with exception to the Full Recap Service as I will provide new capacitors from Console5)
Tim Worthington RGB Install – $80.00
This is a modification board for the Atari 2600 which adds audio/video outputs to this console which has only a modulated RF output available normally. It improves the picture quality and makes it easier to connect to modern TV sets that no longer have an analog tuner. It will give you the absolute best and sharpest analog image quality you can get from a 2600 and with the modern V2 kits, you get a handy OSD for pausing and adjusting settings, swapping palettes and more!
V2 kits also ship with an extra feature button you can have wired up (best installed in a controller for pause and reset functions) so be sure to send along the joystick you want it installed in when selecting this service!
The 2600RGB kit can be purchased from:
2600RGB – ETIM Online Shop
PLEASE NOTE: There are multiple options for the output connector to use with this kit, but it ships with an 8 pin min-din style and is recommended to use that along with the separate 3.5mm audio jack. If you wish to use a different connector or have special wiring/hookup needs please reach out and discuss with me before placing order!
Full System Recap – $30.00
Electrolytic Capacitors have an estimated shelf life of about 15 years and many of these old retro gaming systems are long past that time. Prevent unwanted power, video or audio issues by proactively replacing these in your 2600 system. If your 2600 is already exhibiting issues a failed capacitor could be the culprit and is usually a good first step in the diagnosis and repair. All capacitors will be replaced on the system motherboard with a cap kit from Console5 which I will provide for this service, included in the cost. This also includes several non-electrolytic and styrene caps that come in a refresh kit and recommended to replace per Console5.
Full Service Cleaning – $20.00
After years of heavy use many consoles will exhibit accumulation of dirt, dust and debris and this can not only impact the aesthetic appearance of the system but dirty system components can impact component life and performance. Your console will be completely disassembled and cleaned from the inside out. All PCB and internal electrical components will have dust and debris removed via an electronic air compressor and then be cleaned with 99% isopropyl alcohol and brushed clean. Outer shell and other non-electronic components will be taken apart and soaked in a soap/water mixture and carefully scrubbed to remove stains and debris buildup. Any light markings, scuffs or other blemishes will be safely removed to the best of my ability. Once the console is re-assembled the outer shell will be given a coat of plastic UV protectant to restore shine and prevent UV damage
PLEASE NOTE: While this cleaning service includes the mainboard and shell, it does NOT include cleaning of the switches (4 or 6 depending on model) as that is a much more comprehensive teardown and is covered by an additional switch-only cleaning service below
Switch Cleaning – $20.00
Both the 4 switch and 6 switch versions of the 2600 are prone to issues related to debris/dirt build up, corrosion, etc which can cause any or all of the switches to not register or move freely up and down. This service focuses exclusively on carefully opening each switch and cleaning and applying a fresh coat of deoxit for maximum contact between the slide and contact pads. Solder joints will be checked and reflowed as necessary and if you provide replacement foam pads those will be installed as well
